Enter the parameters as required.

The percentage of the feed materials (i.e. clinker, gypsum, limestone and other) is on a wet basis and must add up to 100%.

The moisture content for feed material must be provided.

The total feed rate to the mill is on a wet basis.

The water injection to the mill includes water injected to the inlet, outlet and in the form of grinding additives.

The ambient pressure is in Pascal and is typically less than 101325 Pa.

Temperature are in degrees Celsius.

The static pressure at the mill inlet is in Pascal. This is typically -100 to -200 Pa, but can be lower in case a hot gas generated is present.

The composition of the gas to the mill is on a dry basis for oxygen and carbon dioxide – the balance will be taken as nitrogen.

The gas flow rate to the mill tube is in normal cubic meters per hour.

The mill tube exit gas temperature is in degree Celsius. Typically 100 to 120°C.

The pressure at the mill tube exit is in Pascal. Typically -800 to -2000 Pa.